Sand fighter on beds O 03 ospeed 2.6821637 odirect 0.0 ostdspeed 2.6821637 ominspeed 1.3410819 omaxspeed 3.129191 op_notes3 This is a clone from Sand Fighter. This is used between the beds to roughen the surface. This is a row crop tool. The ridge roughness is maintained from the prevous tillage. Sandfighter makes roughened surface with spade points mounted on spiderwheels mounted on a shaft. Similar to a rotary hoe except spade points are further apart and not pointed. Also similar to a mulch treader but not as agressive and not operated on a skew. 04-01-02 DTL G2 was added into file in front of the flattening (P24), burial (P25), and resurfacing (P26) factors because the area affected is less than 1.0 and the RUSLE values were normalized to 1.0. This change will imulate the correct residue changes based on the method set forth in RUSLE. RUSLE's factors have been redused to based on the area affected. The stalk fall rate factor (P34) was moved ahead of the new (G2) factor to set the fall rate to the less than 1.0 area affected. Burial rates are changed to match a rotary hoe and the area effected is reduced to 50% because of the area not touched by the tool. 7-27-10 MAS oenergyarea 4.1157265 ostir 19.89 G 01 gtdepth 76.20015 gtilint 0.5 gtilArea 0.50 gtstddepth 76.20015 gtmindepth 25.400051 gtmaxdepth 101.600204 P 01 P 02 rroughflag 1 rrough 10.160021 P 05 rdgflag 0 rdghit 25.4000508001016 rdgspac 152.4003048006096 rdgwidth 0 dkhit 0 dkspac 0 P 11 asdf 3.0 crif -0.22 P 12 soilos 0.7 P 13 laymix 0.5 P 34 frselpool 3 ratemultvt1 3.0 ratemultvt2 2.5 ratemultvt3 2.0 ratemultvt4 1.5 ratemultvt5 1.0 threshmultvt1 0.8 threshmultvt2 0.85 threshmultvt3 0.9 threshmultvt4 0.95 threshmultvt5 1.0 G 02 gbioarea 1.0 P 24 fbioflagvt 14 massflatvt1 0.25 massflatvt2 0.2 massflatvt3 0.25 massflatvt4 0.1 massflatvt5 1.0 P 25 burydist 1 massburyvt1 0.2 massburyvt2 0.2 massburyvt3 0.15 massburyvt4 0.15 massburyvt5 0.323 P 26 massresurvt1 0.05 massresurvt2 0.05 massresurvt3 0.05 massresurvt4 0.07 massresurvt5 0.05