Bed shaper, 12 in O 03 ospeed 2.2351363 odirect 0.0 ostdspeed 2.2351363 ominspeed 1.5645955 omaxspeed 2.9056773 op_notes3 RUSLE:Bed shaping operation on existing 12" high beds. May include drip tape installation. 11/18/01 DTL G2 was added into file in front of the flattening (P24), burial (P25), and resurfacing (P26) factors because the area affected is less than 1.0 and the RUSLE values were normalized to 1.0. This change will imulate the correct residue changes based on the method set forth in RUSLE. RUSLE's factors have been redused to based on the area affected. The stalk fall rate factor (P34) was moved ahead of the new (G2) factor to set the fall rate to the less than 1.0 area affected. 8/8/07 MAS oenergyarea 4.2092657 ostir 19.5 G 01 gtdepth 101.600204 gtilint .6 gtilArea .75 gtstddepth 101.600204 gtmindepth 76.20015 gtmaxdepth 152.4003 P 01 P 02 rroughflag 1 rrough 15.240031 P 11 asdf 3.0 crif -0.22 P 12 soilos 0.75 P 13 laymix 0.05 P 05 rdgflag 1 rdghit 304.8006 rdgspac 760.0 rdgwidth 152.4003 dkhit 0.0 dkspac 0.0 P 34 frselpool 7 ratemultvt1 3.0 ratemultvt2 2.5 ratemultvt3 2.0 ratemultvt4 1.5 ratemultvt5 1.0 threshmultvt1 0.5 threshmultvt2 0.6 threshmultvt3 0.7 threshmultvt4 0.8 threshmultvt5 1.0 G 02 gbioarea 1.0 P 24 fbioflagvt 0 massflatvt1 .95 massflatvt2 0.80 massflatvt3 0.75 massflatvt4 0.3 massflatvt5 1.00 P 25 burydist 1 massburyvt1 0.38 massburyvt2 0.3 massburyvt3 0.23 massburyvt4 0.2 massburyvt5 0.28 P 26 massresurvt1 0.02 massresurvt2 0.02 massresurvt3 0.02 massresurvt4 0.07 massresurvt5 0.02