Bed shaper O 03 ospeed 2.2351363 odirect 0.0 ostdspeed 2.2351363 ominspeed 1.5645955 omaxspeed 2.9056773 op_notes3 RUSLE Notes: Bed shaping operation on existing beds. May include drip tape installation. 10/28/01 DTL Cloned 2-15-07 MAS G2 was added into file in front of the flattening (P24), burial (P25), and resurfacing (P26) factors because the area affected is less than 1.0 and the RUSLE values were normalized to 1.0. This change will imulate the correct residue changes based on the method set forth in RUSLE. RUSLE's factors have been redused to based on the area affected. The stalk fall rate factor (P34) was moved ahead of the new (G2) factor to set the fall rate to the less than 1.0 area affected. 8/8/07 MAS oenergyarea 3.554491 ostir 19.5 G 01 gtdepth 101.600204 gtilint .6 gtilArea .75 gtstddepth 101.600204 gtmindepth 76.20015 gtmaxdepth 152.4003 P 01 P 02 rroughflag 1 rrough 15.240031 P 11 asdf 3.0 crif -0.22 P 12 soilos 0.75 P 13 laymix 0.05 P 05 rdgflag 1 rdghit 203.20041 rdgspac 760.0 rdgwidth 381.00076 dkhit 0.0 dkspac 0.0 P 34 frselpool 7 ratemultvt1 3.0 ratemultvt2 2.5 ratemultvt3 2.0 ratemultvt4 1.5 ratemultvt5 1.0 threshmultvt1 0.5 threshmultvt2 0.6 threshmultvt3 0.7 threshmultvt4 0.8 threshmultvt5 1.0 G 02 gbioarea 1.0 P 24 fbioflagvt 0 massflatvt1 0.5 massflatvt2 0.45 massflatvt3 0.4 massflatvt4 0.3 massflatvt5 1.00 P 25 burydist 1 massburyvt1 0.38 massburyvt2 0.3 massburyvt3 0.23 massburyvt4 0.2 massburyvt5 0.28 P 26 massresurvt1 0.02 massresurvt2 0.02 massresurvt3 0.02 massresurvt4 0.02 massresurvt5 0.02