Subsoiler O 03 ospeed 2.0116227 odirect 0.0 ostdspeed 2.0116227 ominspeed 1.3410819 omaxspeed 2.2351363 op_notes3 Subsoiler or Vee ripper. Shanks are not in-line but mounted on a heavy vee angled toolbar. rev 012507 DTL G2 was added into file in front of the flattening (P24), burial (P25), and resurfacing (P26) factors because the area affected is less than 1.0 and the RUSLE values were normalized to 1.0. This change will imulate the correct residue changes based on the method set forth in RUSLE. RUSLE's factors have been redused to based on the area affected. The stalk fall rate factor (P34) was moved ahead of the new (G2) factor to set the fall rate to the less than 1.0 area affected. 8/8/07 MAS oenergyarea 19.64324 ostir 32.91 G 01 gtdepth 381.00076 gtilint 0.8 gtilArea 0.75 gtstddepth 381.00076 gtmindepth 304.8006 gtmaxdepth 457.2009 P 01 P 02 rroughflag 1 rrough 30.480062 P 05 rdgflag 1 rdghit 101.600204 rdgspac 914.40186 rdgwidth 0.0 dkhit 0.0 dkspac 0.0 P 11 asdf 2.4 crif -2.0 P 12 soilos 0.8 P 13 laymix 0.25 P 34 frselpool 7 ratemultvt1 3.0 ratemultvt2 2.5 ratemultvt3 2.0 ratemultvt4 1.5 ratemultvt5 1.0 threshmultvt1 0.5 threshmultvt2 0.6 threshmultvt3 0.7 threshmultvt4 0.8 threshmultvt5 1.0 G 02 gbioarea 1.0 P 24 fbioflagvt 0 massflatvt1 0.6 massflatvt2 0.5 massflatvt3 0.45 massflatvt4 0.4 massflatvt5 1.0 P 25 burydist 4 massburyvt1 .304 massburyvt2 0.268 massburyvt3 0.232 massburyvt4 .172 massburyvt5 .34 P 26 massresurvt1 0.01 massresurvt2 0.01 massresurvt3 0.01 massresurvt4 0.1 massresurvt5 0.01