Roller, on beds O 003 ospeed 1.7881091 odirect 0.0 ostdspeed 2.6821637 ominspeed 1.3410819 omaxspeed 3.5762181 op_notes3 Smooth roller on top of beds, can be used before or after planting to compress seed zone on existing beds. Vegetation is not killed. oenergyarea 2.338481 ostir .39 ofuel op_devnotes3 Smooth roller on top of beds after planting as in sugarcane production. Only the top of the beds is compacted 02-01-02 DTL G2 was added into file in front of the flattening (P24), burial (P25), and resurfacing (P26) factors because the area affected is less than 1.0 and the RUSLE values were normalized to 1.0. This change will imulate the correct residue changes based on the method set forth in RUSLE. RUSLE's factors have been redused to based on the area affected. The stalk fall rate factor (P34) was moved ahead of the new (G2) factor to set the fall rate to the less than 1.0 area affected. 8/8/07 MAS Created 11-30-07 MAS When running the roller after a crop was planted the stand was being reduced 95% in soybeans in MN. Switch the flattening from Crop and Residue to only Residue being flattened. This allows the crop to spring back after the roller. MAS 4-6-11 LMOD and WEPS update correlation; existing WEPS operation record, 160410 jkp G 001 gtdepth 25.400051 gtilint .5 gtilArea 0.4 gtstddepth 25.400051 gtmindepth 25.400051 gtmaxdepth 25.400051 P 001 P 002 rroughflag 1 rrough 7.6200156 P 005 rdgflag 1 rdghit 203.20041 rdgspac 762.0015 rdgwidth 0.0 dkhit 0.0 dkspac 0.0 P 011 asdf 3.0 crif -0.22 P 034 frselpool 7 ratemultvt1 3.0 ratemultvt2 2.5 ratemultvt3 2.0 ratemultvt4 1.5 ratemultvt5 1.0 threshmultvt1 0.5 threshmultvt2 0.6 threshmultvt3 0.7 threshmultvt4 0.8 threshmultvt5 1.0 G 002 gbioarea 1.0 P 024 fbioflagvt 14 massflatvt1 .95 massflatvt2 .95 massflatvt3 .95 massflatvt4 .95 massflatvt5 1.0 P 025 burydist 1 massburyvt1 0.05 massburyvt2 0.05 massburyvt3 0.05 massburyvt4 0.05 massburyvt5 0.05 P 026 massresurvt1 0.01 massresurvt2 0.01 massresurvt3 0.01 massresurvt4 0.01 massresurvt5 0.01