\documentclass[10pt,letterpaper, final]{report} % \documentclass{} required in all files

\usepackage{../preamble/myWEPS} % This is now our single preamble file inclusion (it assumes a “.sty” file extension)

\begin{document}
There are three crop interval reports, a \textbf{Crop Interval Summary Report},
\textbf{Crop Interval Detail Report} and a \textbf{Crop Interval Period Detail Report}.
The Crop Interval Summary Report (\cref{fig:Crop_Interval_Summary_Report})
only contains a statistical summarization
of the individual management rotation year crop interval data
consisting of the mean, standard deviation, minimum and maximum values.
The Crop Interval Detail Report (\cref{fig:Crop_Interval_Detail_Report})
contains the summarized crop period data results along with the statistical summarization data.
The Crop Interval Period Detail Report (\cref{fig:Crop_Interval_Period_Detail_Report})
contains the individual management rotation year-by-year crop period
and crop interval data results along with the statistical summarization data
for the crop periods and crop intervals.
All three reports contain the standard simulation run information
in its initial header section
\cref{fig:Report_Header_Section},
including the names of the input files.

Crops intervals consist of the period following the previous crop’s termination
until the termination of that crop.
For typical row crops, these dates usually correspond to the previous crop’s harvest date
to this crop’s harvest date, assuming the harvest dates terminate the crop.
Cropping periods are defined as the period between the previous crops’ termination
and the planting of the current crop, if this period exists,
and is identified as \textbf{CP$\_$0} in the crop interval reports.
The cropping (crop growth) period that refers to crop planting until harvest
is identified as \textbf{CP$\_$1} in the crop interval reports.
For multiply harvested crops, such as alfalfa, the additional crop growth/harvest periods
are referred to as \textbf{CP$\_$2}, \textbf{CP$\_$3}, etc.
If a crop can continue to grow (re-grow) after the final harvest
and is not explicitly terminated by that harvest operation,
a final \textbf{cover crop} period (a period where a crop is growing but not harvested)
is defined for that time interval.

The table heading lists the beginning and the end dates for the periods indicated,
the total numbers of days for the period and the name of the crop (for crop intervals)
or the operation that concludes the crop period.
The individual column labels are:

\begin{itemize}[label={}]

\item{Column 1, labeled \textbf{Biomass}, consists of the above ground biomass grown
during the period indicated and reported on a dry matter basis
in lbs/ac (English units) or kg/m$^2$(SI units).}

\item{Column 2, labeled \textbf{Rain}, consists of the total precipitation received
in inches (English units) or mm (SI units) during the period specified.}

\item{Column 3, labeled \textbf{Irrig}, consists of the total irrigation water applied
in inches (English units) or mm (SI units) during the period specified.}

\item{Column 4, labeled \textbf{Runoff}, consists of the total surface runoff of water
in inches (English units) or mm (SI units) during the period specified.}

\item{Column 5, labeled \textbf{Drainage}, consists of the total drainage of water
through the soil profile in inches (English units) or mm (SI units) during the period specified.}

\item{Column 6, labeled \textbf{Evap}, consists of the total soil surface evaporation of water
in inches (English units) or mm (SI units) during the period specified.}

\item{Column 7, labeled \textbf{Crop Transp}, consists of the total water transpired
through the growing crop reported in inches (English units) or mm (SI units) of water
during the period specified.}

\item{Column 8, labeled Initial \textbf{SWC}, consists of the initial soil water content
in the soil profile reported in inches (English units) or mm (SI units) of water.}

\item{Column 9, labeled \textbf{Final SWC}, consists of the final soil water content
in the soil profile reported in inches (English units) or mm (SI units) of water.}

\item{Column 10, labeled \textbf{SWC Change}, consists of the change in soil water content
in the soil profile reported in inches (English units) or mm (SI units) of water
for the period specified.
A negative value means that the stored soil water amount has decreased during the period.
A positive value means that the stored water increased during the period.}

\item{Column 11, labeled \textbf{Runoff Loss}, consists of the percent of surface water runoff
lost during the  period specified.}

\item{Column 12, labeled \textbf{Drainage Loss}, consists of the percent of total water lost
through the soil during the period specified.}

\item{Column 13, labeled \textbf{Evap Loss}, consists of the percent of total water
lost to surface evaporation during the period specified.}

\item{Column 14, labeled \textbf{Water use Eff.}, consists of the percent of total water
transpired through the growing crop during the period specified.
Note that not all periods contain a growing crop \textbf{(CP$\_$0)},
thus not all report sections will display this column.}

\item{Column, 14, labeled \textbf{Water Storage Ratio}, consists of the fraction of water
stored during a non-crop period \textbf{(CP$\_$0)}.
It is not displayed for periods consisting of a growing crop and the \textbf{Water use Eff.}
value is displayed instead.}

\item{Column 15, labeled \textbf{Fallow Eff.}, consists of the total water gained or lost
during the period specified and is expressed as a fraction.
This term is only useful for periods where there is no crop growing, e.g. a “fallow period”
or \textbf{CP$\_$0} labeled periods in the Crop Interval Detail Report
and the Crop Interval Period Detail Report.}

\end{itemize}

\subsection{Crop Interval Summary} \label{subsec:Crop_Interval_Summary_Report}
The WEPS Crop Interval Summary Report screen only contains a statistical summarization
of the individual management rotation year crop interval data
consisting of the mean, standard deviation, minimum and maximum values
for each crop interval as shown in (\cref{fig:Crop_Interval_Summary_Report}).

\begin{figure}[H]
\centering
	\includegraphics[scale=0.6]{images/Reports/crop_interval_summary_1.jpg}
\caption{WEPS Crop Interval Summary Report.}
\label{fig:Crop_Interval_Summary_Report}
\end{figure}


\subsection{Crop Interval Detail Report} \label{subsec:Crop_Interval_Detail_Report}
The Crop Interval Detail Report screen (\cref{fig:Crop_Interval_Detail_Report})
consists of the individual crop periods 
(\textbf{CP$\_$0, CP$\_$1, CP$\_$2,} etc.)
results along with the statistical summarization of the crop interval data provided
in the Crop Interval Summary Report.

\begin{figure}[H]
\centering
	\includegraphics[scale=0.6]{images/Reports/crop_interval_detail_1.jpg}
\caption{WEPS Crop Interval Detail Report.}
\label{fig:Crop_Interval_Detail_Report}
\end{figure}

\subsection{Crop Interval Period Detail Report} \label{subsec:Crop_Interval_Period_Detail_Report}
The Crop Interval Period Detail Report screen (\cref{fig:Crop_Interval_Period_Detail_Report})
consists of the individual management rotation year-by-year crop interval
and crop period data results along with the statistical summarization of the crop interval
and crop period data provided in the Crop Interval Detail Report.
The individual management rotation crop period and crop interval years
are listed with a column heading
of \textbf{Rot.~Cycle}
to indicate which management rotation cycle is being reported for each row.

\begin{figure}[H]
\centering
	\includegraphics[scale=0.6]{images/Reports/crop_interval_period_detail_1.jpg}
\caption{WEPS Crop Interval Period Detail Report.}
\label{fig:Crop_Interval_Period_Detail_Report}
\end{figure}

\end{document}